I use the Embedded Rule Model a lot. Excessively so. Although configuring it takes only a few actions, after personalizing the component, all I need to do is drag and drop and it’s ready to use.
In my environment, I’ve done the same for the Hanging Path Trigger component, among others.
Clik here to view.
It’s very simple to do; drag a component out to the canvas, configure it the way you want, then right-click the component and “Save as Default Configuration”.
Image may be NSFW.
Clik here to view.
You can configure the internal model of some components as well. I’ve pre-configured my Embedded Rule Model component with the usual paths I need for my projects.
Clik here to view.
Hopefully this helps speed and ease development for you, if only a bit.
To reset the component back to the defaults, just delete the personalization like so:
Image may be NSFW.
Clik here to view.
Featured Components
Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
